D-MAX AHD-7808gn CCTV DVR FLASH DUMP

AHD-7808gn

D-MAX AHD-7808gn CCTV DVR

D-MAX Ahd-7808gn DVR flash dump file is shared for repairing purpose. If the D-MAX Ahd-7808gn DVR does not turn on mean not leaving the standby position or no display and even the control buttons/keys on DVR not working then flash dump file can be loaded. If the D-MAX Ahd-7808gn DVR is dead. Mean no power no flash light or indicator then first check the physical damage/burnt area, short circuit on the mainboard. In start check the main input if available then also check the power cable/wire continuity. If both are found ok and D-MAX Ahd-7808gn DVR is still dead then visually check the mainboard and if found ok then test/measure the core voltage. In this case if fault diagnose in power supply and can be repaired then no need to load flash dump file the DVR will be normal after repairing and if the standby light is indicating and the DVR not leaving standby or no any display and also all the core voltage of the main board of the D-MAX Ahd-7808gn DVR are measured and found accurate then write flash dump file, hope the issue will be resolved by rewriting flash memory.

For writing flash dump file in D-MAX Ahd-7808gn DVR board, first of all save the backup of old dump then erase the flash chip. After it write the given D-MAX Ahd-7808gn DVR flash dump and then verify after completion. if verifies successfully then resold it again and check. In some cases the flash dump file is saved from the same board but the channel capacity is different. In these cases you can write the flash dump file it may work but extra channels will be displayed on screen.

Technical Specifications D-MAX Ahd-7808gn DVR:

  • Make/Brand: D-MAX
  • DVR Model: AHD-7808GN
  • Main Board/Chassis: 8286_8AHD_V1.0
  • Power Source: DC 12V
  • Main Processor/Chipset:
  • SPI Flash: 25L128
  • Channel Capacity: 4 CH
  • Firmware Type: SPI Dump

DVR Info:

Special Note:

The attached D-MAX Ahd-7808gn software is backup dump file and can be loaded by a programming tool in case when DVR stuck on Logo or Boot Screen or not leaving the standby position or display screen malfunctioning. Not for Update purpose if DVR is working Normal. Always match Main board number before writing the Flash Dump File. If you are not a technician or do not have any experience of repairing electronic devices then do not play with this. In case of wrong file loaded, board may be dead. Admin Team is not responsible in case of any damage/loss.

DOWNLOAD LINK

Click for more Flash Dumps

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

error: Content is protected !!

Adblock Detected

Please Close Ad Blocker and Refresh The Page Download Start Automaticly