T.R83.031 ALL RESOLUTIONS FREE SOFTWARE

RDA8503

T.R83.031 UNIVERSAL LED TV BOARD

T.R83.031 Universal TV Board software file is shared for repairing purpose. If the T.R83.031 Universal TV Board does not turn on mean not leaving the standby position or the remote control is not responding and even the control buttons/keys on Universal TV Board not working then this software file can be loaded by USB. If the T.R83.031 Universal TV Board is dead. Mean no power no flash light or indicator then first check the physical damage/burnt area, short circuit then power supply. In start check the fuse of main input if available then also check the power cable/wire continuity because in case of short circuit mostly the fuse burnt and cut off the supply.

If both are found ok and T.R83.031 Universal TV Board is still dead then check the primary power circuit (AC to DC Module or DC Adapter) if found ok then test the secondary power circuit. In this case if fault diagnose in power supply and can be repaired then no need to load software file the TV board will be normal after repairing and if the standby light is indicating and the TV Board not leaving standby or not responding remote and also all the primary and secondary voltage of the T.R83.031 Universal TV Board are tested and found accurate then load software file, hope the issue will be resolved by installing this USB Boot Software.

T.R83.031

Installation Instructions:

For installing USB Boot file in T.R83.031 Universal TV Board board, first of all save the backup if you have any programming device. This software file is compatible with T.R83.031 Universal TV Board. USB Disk must be formatted with FAT32 system. Mostly new FAT 32 devices are not supported for USB Boot so, make sure that USB disk is compatible. Transfer the given software file into USB disk without any folder and plug in into USB port of T.R83.031 Universal TV Board Mainboard and power on. It will flash automatically. After Completion remove the USB disk and power on the TV Board. Hope it will be normal now. If you have any problem by installing software then Read Here.

Technical Specifications T.R83.031 Universal TV Board:

  • Make/Brand: China
  • Main Board/Chassis: T.R83.031
  • Board Type: Universal Non-Combo Jumper Board
  • Jumper Board Setting: 3V, 5V, 12V
  • Power Source: DC-12V
  • Screen Supported: 14″ to 85″
  • Display Format: 1080P
  • Main Processor/Chipset: RDA8503C
  • SPI Flash: 25Q32
  • Tuner: R84X
  • Firmware Type: USB BOOT

Special Note:

The attached software is USB Boot file and can be loaded by a USB Disk in case when Universal TV Board stuck on Logo or Boot Screen or not leave the standby position. Not for Update purpose if Universal TV Board is working Normal. Always match Main board number before installing software. If you are not a technician or do not have any experience of repairing electronic devices then do not play with this. In case of wrong file loaded, board may be dead. Admin Team is not responsible in case of any damage/loss.

T.R83.031 ALL RESOLUTION SOFTWARE DOWNLOAD LINKS:

Related Articles

2 Comments

Leave a Reply

Your email address will not be published. Required fields are marked *

error: Content is protected !!

Adblock Detected

Please Close Ad Blocker and Refresh The Page Download Start Automaticly